Yanos Calibration Tool (yCALI)

A unified user interface for calibration.

The Yanos Calibration Interface (yCALI) is used to calibrate the parameters from cRIOs, PLCs, and devices using the yDEX Engine.
All calibrations are stored and processed on each device, this allows any client to have guaranteed calibrated data when requested, even non-intelligent devices thanks to the yDEX Engine.
The calibration interface consolidates all devices into a single interface and allows the user to quickly switch between the desired devices.
yCALI allows the user to perform multi-point and multi-channel calibrations, this saves time for the calibrator and simplifies the calibration process significantly.

Trust-Worthy Verification

Verify all your applied calibrations.

The yCALI verification interface is used to verify any applied calibration curve, ensuring all calibrations are up to their required standards.
The verification table displays the following key parameters:
- User-defined set point.
- Observed/Calibrated measured value.
- Deviation between the set point and the observed value.
- Allowable tolerance.
- Hysteresis.
- Date when the verification point was captured.
- Standard used to inject the reference signal.
yCALI is able to check the allowable tolerance for each verification point and notify the calibrator if any point exceeds it.
yCALI can provide the user with a full calibration history report that can be easily customized as per customer requirements.